Lumatek Electronic Ballast 600 Watt Twin Dimmable

Electronic ballast by Lumatek 600 watt twin - dimmable

This electronic ballast can be operated with HPS and MH bulbs and used as 400 W and 600 W ballast.

To ensure a safe operation, the Lumatek Ultimate unit is programmed with an automatic shut-off mechanism, which gets activated in case of a short-circuit, during the insertion of a defective lamp or when a lamp is missing. The ballast is equipped with the best electromagnetic shielding available on the market. The electronic ballast operates completely noiseless and is surrounded by a sealed resin housing. Each unit is submitted to a 12-hour testing cycle in the factory to ensure maximum reliability. 

Benefits: 
- Simultaneous operation of two bulbs with a single ballast
- Operation of 2x 400 W, 2x 600W or 1x 400W and 1x 600W possible 
- Very low temperature development at the housing and noiseless during operation
- Higher light output than non-electronic ballasts - up to 27% more according to Lumatek
- Higher light output than electronic, "no-name" ballasts - up to 15% more according to Lumatek 
- Optimal utilization of the bulb power in terms of duration and peak performance
- Maximum lumen through booster in the final stages of the plant
- Heat reduction during summer by dimming down
- Power saving due to smaller grow bulb
- Switchable during operation

Technical details:
- Dimensions L x W x H (mm): 510 x 114 x 81
- Weight (kg): 4.8
- Material: Aluminum housing with cooling fins
- Operating modes: 360W - 400W - 600W - 600SL (Super Lumen boost up to 660W)
- Voltage: 220 - 240V 50/60Hz
- Current (A): 3.0 (x 2)
- Input power (W): 380 - 424 - 635 - 695 (x2)
- Output power (W): 360 - 400 - 600 - 660 (x 2)
- Operation frequency (kHz): < 90
- Power factor: 0.99
- THD (%): < 8
- Efficiency (%): 95
- Supply voltage range (V): 175 - 275
- Suitable ambient temperature at full load from -25 ° to - 40 °
- Humidity: Usable at a relative humidity of 0% to 90%

Scope of delivery:
1x plug cable approx. 2 meter long and 2x cable to the reflector (IEC connector), approx. 4 meter long. Both cables are included and can be easily connected.